How to put in Streamyx ID and password after reset modem

How to put in Streamyx ID and password after reset  modem 1
Innacomm W3400V6 WAN Services settings

Your Streamyx modem internet LED showing red light after reset modem, learn how to put in Streamyx login ID and password after reset modem to solve the issue. Basically, your modem will reset all its setting and restore to its factory or default setting after you press the reset button which is located at the back of the modem.

Since many of you contacted me regarding Streamyx modem showing red light after reset the modem, to be exact, after following my tutorial on how to reset Streamyx modem here and I agree that I didn’t provide you detail enough the step-by-step on how and where you can put your Streamyx login ID and password to make it works again.

To make it works again, the most important step is you need to put in your Streamyx login ID and password. Technically, this is because the Streamyx modem will need your login information to establish the connection between the modem and the Streamyx server and finally connect you to the internet.

Note: This tutorial is for TM Streamyx Innacomm W3400V6 modem.



First, connect your computer to the router wired or wireless.

Make sure you remember the login information. If you haven’t change them, the default are as follows:

  • Username/ID: tmadmin
  • Password: Adm@XXXX (XXXX is the last 4 digit of your modem MAC address)

Put in Streamyx ID and password after reset modem

Actually, there are two methods to reconfigure your Streamyx account after reset modem. The fastest way is to use the Quick Setup, and the other one is by manually configure your account.

If you prefer the manual method, the detail steps are as follows.

  1. Open any internet browser.
  2. Go to
  3. On the login page, enter your login information and click Login.
  4. Select Advanced Setup menu.
  5. Select WAN Service sub-menu.
  6. Click Add button.
  7. In PPP Username box, enter your Streamyx ID.
    • For example: yourname@streamyx
    • If it is missing, please call 100 for help
  8. In PPP Password box, enter your Streamyx password.
    • Both of this information — Streamyx login ID and password were usually written on the router box by the service technician
    • If it is missing, please call 100 for help
  9. In PPPoE Service Name box, leave it blank.
  10. In Authentication Method box, select AUTO.
  11. Check the box for the following:
    • Enable NAT
    • Enable IPv6 for this service
    • Request IPv6 address
    • Request Prefix Delegation
  12. Check the box for Bridge PPPoE Frames Between WAN and Local Ports.
    • For MTU Size, put in 1492
    • For TCP MSS, put in 1452
  13. Click Next button.
  14. Click Apply/Save button to save the setting.

Done. Hopefully, you will be able to configure back your Streamyx modem and connect to the internet.


I tried my best to explain the detail step by step in the above tutorial. However, if you find them a little bit hard, you can refer the modem manual on how to use Quick Setup method.

If you have any issue, let me know in the comment.

Articles you may like
Leave your comment

Latest Comments

  1. Diyana Sofea
  2. Yi Joe Siow
  3. Gua Serangga
  4. Apiet Osman
  5. Faiz Tallboy
      • Faiz Tallboy
  6. Violet

Leave a Reply

Barzrul Tech uses cookies to ensure you get the best experience while browsing the site.Read more >>
Share via
Copy link
Powered by Social Snap